RE: Debug audio section noise

It was a 60hz hum with a regular clicking nose. Got much louder when my had
moved near it. Along with serious static when adjusting the volume pot.

I replaced the volume pot and the hum / static went away completely.

Thanks for the tips.

David

-----Original Message-----
From: owner-rasterlist@vectorlist.org
[mailto:owner-rasterlist@vectorlist.org] On Behalf Of
solarfox@triluminary.net
Sent: Thursday, August 02, 2012 8:42 PM
To: rasterlist@vectorlist.org
Subject: Re: RASTER: Debug audio section noise

On Tue, 31 Jul 2012 22:42:46 -0700, you wrote:

>I have a babypac vidiot board which getting my hand anywhere near the
volume
>pot makes it put out a big racket. Running my finger along the various
caps
>/ resistors in that section also sets up a nice noise. I have another of
>the same board where the above don't cause any problem.
>
>I am a bit weak in analog so short of shotguning the various components I
am
>looking for a clue on where about to start.

        Well, the first place to start is -- what *kind* of noise are you
talking about, here? Is it a 60Hz hum, or a high-frequency squeal, or
static, or... what? Is it continuous, or intermittent?

        If it's a static-y sound that mostly occurs when you touch or wiggle
the components on the board, the most obvious suspects would be a bad pot,
or cracked solder joints around the various components. If the chips are
socketed, it could also be oxidization on the chip legs.

        If it's a hum, especially a 60Hz hum, I'd put a scope on "+12V
Unreg"
to see if that +12V has a lot of AC ripple on it, which would suggest a bad
diode or filter capacitor in the power supply section.

        If none of the above, then a more complete description of the type
of
noise might help narrow it down a bit. :)
----------------------------------------------------------------------------
-
"I thought I told you to look after him!"

"He'll be all right; he's a Time Lord."

"That's just what they're *called*; it doesn't mean he actually knows what
he's doing!"
----------------------------------------------------------------------------
-
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Fri Aug 10 03:22:14 2012