Re: Fluke 9010A Input voltage

Steve,

There is no panel nor switch on the back. However there is a note referring to the manual (orientation of the mains circuit board). Unfortunately I was not able to locate any information about this in the service manual. I was hoping someone had done this before and could tell me immediately what actions to perform.

Best regards,

Filip
  ----- Original Message -----
  From: Steve C
  To: 'Technical Tools Mail List'
  Sent: Monday, October 31, 2005 7:59 PM
  Subject: RE: [Techtoolslist] Fluke 9010A Input voltage

  Yes, there is a panel on the back that allows voltage selection - I can't remember how but it was easy.

  Steve

  -----Original Message-----
  From: techtoolslist-bounces@flippers.com [mailto:techtoolslist-bounces@flippers.com] On Behalf Of Filip Hautekeete
  Sent: 31 October 2005 13:27
  To: techtoolslist@flippers.com
  Subject: [Techtoolslist] Fluke 9010A Input voltage

  Hi all,

  Is there any easy way to switch the Fluke 9010A from VAC 120 (factory installed) to VAC 240 ?

  Best regards,

  Filip

------------------------------------------------------------------------------

  _______________________________________________
  Techtoolslist mailing list
  Techtoolslist@flippers.com
  http://seven.pairlist.net/mailman/listinfo/techtoolslist

_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
Received on Mon Oct 31 14:08:14 2005