Re: Fluke 9010

From: Martin White <martin_at_guddler.co.uk>
Date: Sun Nov 19 2006 - 09:16:18 EST

Chris,

What¹s the cpu? The service manual shows ³536094² but not too sure if this
is a Fluke part number or what? Is that the actual number on the cpu?

Just read through some interesting stuff on the tape drives in the service
manual so I may open mine up at some point and see if I can work out what¹s
up with the drive. Used to work fine until it was stored for a few months.
When it came out of storage it no longer works. Never really bothered about
it too much since I have the RS232 option but it would be nice to get it
going again!

Martin.

On 19/11/06 12:47, "Chris Toseland" <Chris@muppzlab.co.uk> wrote:

> Hi folks,
>
> This maybe a long shot but does anyone have or can duplicate the controller
> CPU for the tape drive unit on a 9010?
> My tape unit doesn't work, I've checked the sensors and even tried driving the
> CPU input pins directly all to no avail so I and can only assume that the CPU
> is dead.
>
> Thanks
>
> Chris
>
>
> _______________________________________________
> Techtoolslist mailing list
> Techtoolslist@flippers.com
> http://seven.pairlist.net/mailman/listinfo/techtoolslist

-- 
Guddler's Domain
http://www.guddler.co.uk

_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
Received on Sun Nov 19 09:16:39 2006

This archive was generated by hypermail 2.1.8 : Sun Nov 19 2006 - 09:50:00 EST