Re: 9010a RS232 problem?

It's doing a power on reset, after pressing "Aux i/f", then "Read", then
"Enter". It will state Receiving, then reset after about 2 secs. It then
comes back on stating Fluke 9000 restarted, self test ok.

Kevin

On Tue, Jan 5, 2010 at 8:28 AM, Tim Matthews <trmatthe@gmail.com> wrote:

> >
> > > -----Original Message-----
> > > From: techtoolslist-bounces@flippers.com
> > > Subject: Re: [Techtoolslist] 9010a RS232 problem?
> > >
> > > It's not a pod problem, I can use the fluke normally w/o problem. I'm
> > > trying
> > > to hook up the rs232 to a computer to upload scripts. It only resets
> > after
> > > hitting enter/yes after doing an Aux/if, read. while trying to send a
> > > script
> >
>
> Hi Kevin,
>
> Can you describe exactly what is being shown on the Fluke display when it
> fails?
> I'm not sure if you are describing the Fluke doing a Power-On Reset, or
> whether it's
> just dropping out of RX mode.
>
> cheers
> tim
> _______________________________________________
> Techtoolslist mailing list
> Techtoolslist@flippers.com
> http://seven.pairlist.net/mailman/listinfo/techtoolslist
> FTP site is: ftp://ftp.flippers.com/TTL/TestEquipment
> Archive site: http://seven.pairlist.net/pipermail/techtoolslist/
>
_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
FTP site is: ftp://ftp.flippers.com/TTL/TestEquipment
Archive site: http://seven.pairlist.net/pipermail/techtoolslist/
Received on Tue Jan 5 11:22:01 2010