They were custom, the only parts I didn't fab were the bearings, encoder disc
and the coupler pcb. I tried the new shafts out of 304 stainless as opposed to
carbon steel and a case hardening. We will see how they hold up over time.
James
"Christopher X. Candreva" wrote:
> On Sat, 19 Feb 2000, James Marous wrote:
>
> > of stock nylon for the roller insert. Email me if you have any
> > questions. Here's the link:
>
> Did you use standard shafts, or are they custom. I've got an original
> roller controller in mine, but it could use a new pair of shafts.
>
> -Chris
>
> ==========================================================
> Chris Candreva -- chris@westnet.com -- (914) 967-7816
> WestNet Internet Services of Westchester
> http://www.westnet.com/
>
> ---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.
-- mailto:jamesm@erinet.com My Homepage! http://www.erinet.com/jamesm -- For the 'bots :-) mailto:root@localhost mailto:abuse@localhost mailto:postmaster@localhost
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Sat Feb 19 11:35:13 2000
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:30:58 EDT