Re: XY deflection Proto

If you increase the voltage and made some tweeks it should be really close
if not the same as the Go8.

Fred

----- Original Message -----
From: "Joe Magiera" <joemagiera@ameritech.net>
To: <vectorlist@synthcom.com>
Sent: Wednesday, June 12, 2002 12:34 AM
Subject: Re: VECTOR: XY deflection Proto

> So are you saying your replacement will match performance/quality of a
> WG6401?
>
> Joe
> joemagiera@ameritech.net
>
> ----- Original Message -----
> From: "Jilayne Stanclif" <jstancliff@mchsi.com>
> To: <vectorlist@synthcom.com>
> Sent: Tuesday, June 11, 2002 10:11 PM
> Subject: VECTOR: XY deflection Proto
>
>
> > Allright this is what I think will work the best as far as deflection.
> This
> > is the design I am using on my Proto right now less the 2 extra
> transistors
> > on the output.
> > Nothing special here pretty much a copy of the 6400 Mark Spath can tell
> you
> > that ;) ,
> > but with cheap transistors. The tip35c and 36c can go up to 100V so if
you
> > kept adding them, decrease the yoke windings and increase the voltage
you
> > could probably get what ever slew you wanted. I messed up on the 2 3 ohm
> 10
> > watt resistors scratch that. It needs 2 10 watt .75 or close resistors
in
> > series. I made more heat putting them the way they are now. The
resistors
> > not marked are the one's that would have to be adjusted for higher
> voltages.
> >
> > Fred
> >
> >
> >
> > http://home.mchsi.com/~jstancliff/wsb/media/26501/site1056_t.jpg.
> >
>
> --------------------------------------------------------------------------
> -
> > ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
> the
> > ** message body to vectorlist-request@synthcom.com. Please direct other
> > ** questions, comments, or problems to vectorlist-owner@synthcom.com.
>
> --------------------------------------------------------------------------
-
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to vectorlist-owner@synthcom.com.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
Received on Tue Jun 11 23:01:47 2002