Re: Anyone have any troubleshooting advice?

>
>
>>The output of the X multiplier (C12) looks good, pin 14 (output) is same as
>>pin 9 (input) but downscaled.
>>
>>The output of Y 1495 (C13) looks bad, pin 14 (output) bears no similarily to
>>pin 9 (input). Also, the input is perhaps somewhat skewed, hard to tell on
>>the scope.
>>
>>I socketed C13 and replaced it (known good one), with no change.
>>
>>

Probably a stupid question, but did you check ALL pins, especially the
power supply pins?

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
Received on Sun Feb 9 13:13:03 2003