Re: Pictures of your Star Wars

> Some have suggested adding a ground wire between the power supply and the
> game PCB. I checked with a meter and found that it registered less than 1
> ohm between earth ground on the transformer assembly and the ground test
> point on the vector generator board. I added a jumper wire between the
two
> just to test, but it appears to have made no difference in quality. I did
> this years ago on my Tempest when it had a similar problem, and this is
> exactly what did the trick. Those vectors looks quite sharp!
>
> Joel-

BUT..

did you add a jump cable between the game pcb GND and the monitor frame?
this is the most crucial for display distortions, not between game pcb and
power brick..

Andy Welburn
www.andys-arcade.com

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
Received on Wed Feb 19 01:27:57 2003