RE: MH and Tempest spinner not compatable?

Thanks... I did notice now that the MH board has a 150 ohm resistor from
ground. The Tempest has a 100. If I change the resistance, I would
assume that it'd work on MH. But, will it still work in the
Tempest...... I guess I'll find out..

-----Original Message-----
From: Louis Srianomai [mailto:louisurfer@yahoo.com]
Sent: Friday, March 14, 2003 1:13 PM
To: vectorlist@synthcom.com
Subject: Re: VECTOR: MH and Tempest spinner not compatable?

Joe,

I think some of the older opto boards work and some don't with MH.

If I recall, the latest one you can buy at happ rev F. works. I think
Mark
used these for his repro roller.

Of the 10 or so tempest CP's I've seen only about half worked with MH.

L.

--- Joe <joe@joesarcade.com> wrote:
>
> Are the MH and Tempest spinners not compatible I did see in the
Tempest
> -> MH conversion that Atari included a new spinner pcb, or is that
> wrong? If so, does anyone have schematics of the MH spinner PCB?
>
> Please help if you can...
>
> Thanks,
> JB
>
>
------------------------------------------------------------------------

---
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE"
in the
> ** message body to vectorlist-request@synthcom.com. Please direct
other
> ** questions, comments, or problems to vectorlist-owner@synthcom.com.
------------------------------------------------------------------------
---
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.