Re: 19v2000 wire-wound resister temp check

From: Rodger Boots <rlboots_at_cedar-rapids.net>
Date: Wed Feb 04 2004 - 14:00:22 EST

Which brings up something to remember about power resistors on circuit
boards---try to space them away from the board so the board doesn't get
burnt. That also allows extra air flow around the resistor to help in
cooling.

Christopher X. Candreva wrote:

>Yes, this poor baby has a lot of problems. :-)
>
>The previous post reminded me of another issue - How hot should the big
>resistors on this monitor get ?
>
>The one in the HV cage is too hot to touch, the two on the edge of the
>defleciton board are almost as bad.
>
>
>
>==========================================================
>Chris Candreva -- chris@westnet.com -- (914) 967-7816
>WestNet Internet Services of Westchester
>http://www.westnet.com/
>---------------------------------------------------------------------------
>** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
>** Please direct other questions, comments, or problems to chris@westnet.com
>
>
>
>

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Wed Feb 4 14:00:32 2004

This archive was generated by hypermail 2.1.8 : Wed Feb 04 2004 - 18:50:01 EST