Re: SW monitor prob...

19500 Volts

At 01:14 PM 4/1/2005, you wrote:
>I have a HV probe,
>its what i used to discharge the monitor, so i could re-cap it. What
>voltage should i set it to ?
>
>
>
>
>
>Pinx
>
>p.s. Col, any parts you have would be much appreciated, also nice to see
>you got the ESB working :)
>
>
>----- Original Message ----- From: "Christopher X. Candreva"
><chris@westnet.com>
>To: <vectorlist@vectorlist.org>
>Sent: Friday, April 01, 2005 8:22 PM
>Subject: Re: VECTOR: SW monitor prob...
>
>
>>On Fri, 1 Apr 2005, Pinx wrote:
>>
>>>"blooming" and so i have just re-capped the HV section, but i still have
>>>the problem. Is there anything else on the HV board i should replace to
>>>cure this problem ?
>>
>>Re-capping isn't really a fix for blooming. Blooming comes from voltage in
>>the HV section. The simple way to check that is with a HV probe, which can
>>be had for under $20 on e-bay usually.
>>
>>If it is low, it can be adjusted, the pot may have just slipped.
>>
>>==========================================================
>>Chris Candreva -- chris@westnet.com -- (914) 967-7816
>>WestNet Internet Services of Westchester
>>http://www.westnet.com/
>>---------------------------------------------------------------------------
>>** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
>>** Please direct other questions, comments, or problems to chris@westnet.com
>
>---------------------------------------------------------------------------
>** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
>** Please direct other questions, comments, or problems to chris@westnet.com

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Fri Apr 1 16:37:24 2005