Re: 6100 HV transformer in an Amplifone HV PCB

The heater output will be the same as used by the Amp as all it is is a bit
of wire wrapped around the core 3 times and connected to ground by a .3ohm
resistor, I will measure for 6v before connecting to the CRT. I have notice
that I will need a 15ohm resistor and a 350v 10uf cap to get the 180 b+
----- Original Message -----
From: "peter jones" <highwayman2000@mail.ru>
To: <vectorlist@vectorlist.org>
Sent: Sunday, March 12, 2006 7:50 PM
Subject: Re: VECTOR: 6100 HV transformer in an Amplifone HV PCB

> Hmmm.
>
> make sure you use a hv probe and stand at the *side* of the tube, not
> infront or behind it.
>
> and the heater probably wont work, or it will blow the tube element.
>
> if the wg has a different number of primary turns then the heater output
> will be wrong - maybe very wrong.
>
> ---------------------------------------------------------------------------
> ** Unsubscribe, subscribe, or view the archives at
> http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to
> chris@westnet.com

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Sun Mar 12 14:54:31 2006