Re: G08 Rebuild issues

ok I 'll check both of those, if you think of anything else please let me know!

On Tue, Dec 25, 2012 at 5:45 PM, Mark Jenison
<eliminator4player@gmail.com> wrote:
> This is another one of those "I've seen this before, wish I had written down
> the fix..."
>
> Offhand, I'd look at the ribbon cable between the xy pair. Then the yoke
> connector.
>
> On Dec 25, 2012 4:36 PM, "Grant Thienemann" <grant.thienemann@gmail.com>
> wrote:
>>
>> Hey Guys,
>>
>> I did the cap kit on my G08 today, and when I hooked the monitor back
>> up to my Star Trek I get scrolling vertical lines. I noticed there
>> were two pots on the HV board, and I know I accidentally moved one of
>> them when I was rebuilding the chassises, what do those two pots do?
>> Its like the horizontal or vertical sync is off, but this is a vector
>> not a raster.
>>
>> Also just messing with it a little bit the more I change the pot the
>> more the vertical lines change. Any help would be fantastic.
>>
>> Thanks
>> Grant
>>
>> ---------------------------------------------------------------------------
>> ** Unsubscribe, subscribe, or view the archives at
>> http://www.vectorlist.org
>> ** Please direct other questions, comments, or problems to
>> chris@westnet.com
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Wed Dec 26 08:09:46 2012