Re: Troubleshooting Star Wars

Ahhhh ok will try again tomorrow with it installed. Many thanks
On Oct 9, 2013 9:32 PM, "Rodger Boots" <rlboots2@gmail.com> wrote:

> Reset not going to work without sound board.
>
>
> On Wed, Oct 9, 2013 at 11:29 PM, Joel Griffin Dodd <griffindodd@gmail.com>wrote:
>
>> Interconnects are good. No I didn't have the sound board installed during
>> these tests.
>> On Oct 9, 2013 9:25 PM, "Rodger Boots" <rlboots2@gmail.com> wrote:
>>
>>> Reset comes indirectly through sound board. Do you have a sound board
>>> installed and are interconnect cables in good shape?
>>> On Oct 9, 2013 11:07 PM, "Joel Griffin Dodd" <griffindodd@gmail.com>
>>> wrote:
>>>
>>>> All my clocks test good on my oscilloscope the only one I haven't found
>>>> a test point for is 1.5mhz where is that point.? Got a solid 1.5mhz at E
>>>> and Q though at the cpu
>>>> On Oct 9, 2013 9:05 PM, "Rodger Boots" <rlboots2@gmail.com> wrote:
>>>>
>>>>> Start looking for where these come from and work your way back. You
>>>>> did check for missing/broken crystal, right?
>>>>> On Oct 9, 2013 11:00 PM, "Joel Griffin Dodd" <griffindodd@gmail.com>
>>>>> wrote:
>>>>>
>>>>>> Yep both still low with CPU removed
>>>>>> On Oct 9, 2013 8:55 PM, "Rodger Boots" <rlboots2@gmail.com> wrote:
>>>>>>
>>>>>>> Could be, remove the CPU and see if they are still low. That will
>>>>>>> tell you if it is the CPU or the board.
>>>>>>> On Oct 9, 2013 10:50 PM, "Joel Griffin Dodd" <griffindodd@gmail.com>
>>>>>>> wrote:
>>>>>>>
>>>>>>>> Hey guys. Troubleshooting my non booting star wars board set.
>>>>>>>>
>>>>>>>> Checked all my voltages and clicks they look good.
>>>>>>>> Firq, NMI and halt are all high
>>>>>>>> However reset is permanently low as is Irq at the CPU.
>>>>>>>>
>>>>>>>> Any ideas where to go from here? Bad CPU?
>>>>>>>>
>>>>>>>> I'm following the star wars troubleshooting guide
>>>>>>>>
>>>>>>>> Joel
>>>>>>>>
>>>>>>>
>

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Thu Oct 10 00:33:48 2013