Re: I, Robot joystick inversion

Unfortunately, there are only four wires coming off the
Hall-Effect PCB - power, gnd, X and Y. Swapping the X
and Y controls leaves me in the same position.

tm

On Mon, 11 March 2002, "David Shoemaker" wrote

>
> This is not a digital output. You would need some
nature of analog
> inverter.
> Have to look at my docs but I would expect that you
could swap the wires
> much as you can with a pot based analog controller.
>
> ----- Original Message -----
> From: "Tom McClintock" <tomm@mgcap.com>
> To: <rasterlist@synthcom.com>
> Sent: Sunday, March 10, 2002 10:10 AM
> Subject: RASTER: I, Robot joystick inversion
>
>
> > I'm swapping out my I, Robot joystick with one of
the
> > 'newer' Hall Effect joysticks (circa 1989). However,
> > the orientation of the hall-effect pcb is such that

> > cannot fit the control panel with joystick onto the
> > cabinet. The hall-effect pcb sticks out about an
inch
> > too much.
> >
> > I can, however, rotate the joystick 180 degrees and
> > everything fits just fine. This also has the
> > challenging effect of inverting my controls - down
is
> > up, and left is right.
> >
> > Is my best solution to wire up a 7404 hex inverter
for
> > the X and Y joystick outputs, or is there something
> > else I am missing?
> >
> >
> > tm
> >
> >
> >
--------------------------------------------------------------------------
> -
> > ** To UNSUBSCRIBE from rasterlist, send a message
with "UNSUBSCRIBE" in
> the
> > ** message body to rasterlist-request@synthcom.com.
Please direct other
> > ** questions, comments, or problems to
neil@synthcom.com.
> >
>
>
---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from rasterlist, send a message
with "UNSUBSCRIBE" in the
> ** message body to rasterlist-request@synthcom.com.
Please direct other
> ** questions, comments, or problems to
neil@synthcom.com.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from rasterlist, send a message with "UNSUBSCRIBE" in the
** message body to rasterlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Mon Mar 11 05:57:20 2002