Re: Re: Zaxxon Electrohome Troubleshoot

From: Rodger Boots <rlboots_at_cedar-rapids.net>
Date: Sun Nov 04 2007 - 19:17:06 EST

Is this the Electrohome that has the polarity of one of the caps marked
wrong on the board?

peter jones wrote:
> -----Original Message-----
> From: Dustin Holden <discuspro@yahoo.com>
> To: rasterlist@vectorlist.org
> Date: Sat, 3 Nov 2007 10:20:29 -0700 (PDT)
> Subject: RASTER: Zaxxon Electrohome Troubleshoot
>
>
>> I've recently finished a cap kit on my Zaxxon's
>> electrohome G07. I did the optional C303 upgrade.
>> I've triple checked that all the capacitors are in the
>> right places, their polarity, and if there are any
>> cold solder joints. To my eyes everything looks fine.
>> Well I installed the board and now I get about 3/4 of
>> the screen. I can actually see the picture, it just
>> looks like it hits a wall 3/4 of the way across the
>> screen, and where it hits the wall it is really
>> intensely bright like everything is compressed into on
>> line.
>>
>>
>
> what did it do before you fitted the kit?
> it may be a bad cap,
> or a wrong cap - one of them should be non-polarised.
>
> as for the other problem, the presets fail along the edge of the board - i replace them all.
>
> ---------------------------------------------------------------------------
> ** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to chris@westnet.com
>
>
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Sun Nov 4 19:17:28 2007

This archive was generated by hypermail 2.1.8 : Sun Nov 04 2007 - 19:50:00 EST