Re: Fluke 9100 Woes, Memory Dip Settings Needed

Mark,

 Try the Service Manual Part 2, page 3-25, Table 3-6. It has the config
switch settings for various RAM sizes.

Have a Merry Christmas All.

Dave
----- Original Message -----
From: "Mark Hooks" <markhooks@earthlink.net>
To: "Techtoolslist" <Techtoolslist@flippers.com>
Sent: Sunday, December 24, 2006 2:00 AM
Subject: [Techtoolslist] Fluke 9100 Woes, Memory Dip Settings Needed

>I just picked up a couple of 9100s with problems. One hangs up in memory
> test. I'm thinking it may not have the dip switch settings set up right.
> I've searched and searched but can't find the settings in the
> documentation.
> I'd appreciate it if someone could send them to me or point me to a manual
> that has them.
>
> The second one doesn't even get that far. It hangs up with no display and
> the Run UUT and Disk Access LEDs lit. Any ideas on how to get these
> running
> would be appreciated.
>
> Mark Hooks
>
> _______________________________________________
> Techtoolslist mailing list
> Techtoolslist@flippers.com
> http://seven.pairlist.net/mailman/listinfo/techtoolslist

_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
Received on Sun Dec 24 16:27:12 2006