Re: Exorcisor on a chip

From: Al Kossow <aek>
Date: Mon Feb 23 1998 - 23:47:29 EST

I just sent a note to Joe that with a pin reassigment and placing the
3 sockets and the 7414 at each corner with the mach part in the center,
you can do the layout on a 1 layer board:

+- -+ +- -+
J1 J3

        mach210

+- -+ +- -+
J2 pwr,gnd 7414

          pins

the ground wraps around the outer edge of the board,
power and clocks go through the center..
Received on Mon Feb 23 20:48:04 1998

This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:30:49 EDT