Re: Dedicated MH Roller Replacement - Finished.

You make the controller, the CPO will be there!

q: would this controller "prefer" a MH PCB with the high or low speed
crystals (ie: ded/conv) ?

-roy-

----- Original Message -----
From: James Marous <jamesm@erinet.com>
To: <vectorlist@synthcom.com>
Sent: Saturday, February 19, 2000 6:56 PM
Subject: Re: VECTOR: Dedicated MH Roller Replacement - Finished.

> Yup, it was all done on Pro/E rel 20. Other than tweaking the flat
development
> of the base, I would say the whole thing took a couple hours (more or
less,
> working on lunch hours and the like). It anyone runs Pro, lmk and I will
be
> glad to send you the model. I have been playing it quite a bit today and
it
> really works great, it might actually roll a little too easy as it's easy
to
> overshoot when you really get it going.
>
> If someone want to make a Tempest conversion roller, I will be happy to
donate
> the time to get the prints done for the roller. I could actually make the
> whole thing 20% smaller or so and still get it all to work. There was
enough
> room on the dedicated cp that space wasn't much of an issue. Heck, I
could
> probably lay out the control panel in Pro/Sheetmetal if you wanted to go
with a
> whole new cp.
>
> James
>
> Clay Cowgill wrote:
>
> > >Unfortunately I don't
> > >have the resources to make these in quantity, but if someone else wants
> > >to try and make them, I will be more than happy to help. I do have a
> > >couple of parts left over, one unbent flat for the base and about a
foot
> > >of stock nylon for the roller insert.
> >
> > Cool... Out of curiosity, is that a Pro-E rendering you had there?
IMHO,
> > it would be cool to make these for conversion kits for Tempest (maybe SD
if
> > there's enough room in the CP). Maybe bribe Roy into making a "roller"
> > control panel overlay for Tempest conversions. ;-)
> >
> > -clay
> >
> > ______________________________________________________
> > Get Your Private, Free Email at http://www.hotmail.com
> >
>
> --------------------------------------------------------------------------
-
> > ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
the
> > ** message body to vectorlist-request@synthcom.com. Please direct other
> > ** questions, comments, or problems to neil@synthcom.com.
>
> --
> mailto:jamesm@erinet.com
> My Homepage! http://www.erinet.com/jamesm
> --
>
> For the 'bots :-)
> mailto:root@localhost mailto:abuse@localhost
> mailto:postmaster@localhost
>
>

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Sat Feb 19 19:21:20 2000