If there is any corrosion, check the integrity of the
traces as well as the sockets in the affected area.
Also, check the solder side of the board - for some
reason Midway didn't spend the extra money to get
the leads trimmed and they get bent and shorted
together all the time. You probably already knew
that...
Alex
http://www.elektronforge.com
ayeckley@elektronforge.com
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Wed Jun 7 07:43:07 2000
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:31:46 EDT