I too have a distortion problem on this monitor when used either on my WICO
XY generator or in a Tempest. the negative horizontal (2N3792) axis is
curved in, not unlike an hourglass. Much less pronounced on the right.
Suggestions?
John :-#)#
At 10:27 AM 20/08/2001, you wrote:
>I am running a wg6100 in a Star Wars. The monitor has a rev 327 deflection
>board. If you take a look at the URL below you will see the problem I am
>getting. The vectors do not line up correctoly and are distorted,
>particularly at the top and bottom. I have obviously capped the monitor
>and replaced ALL the chasis trans. Any help at all would be appreciated.
>
><http://www.densgameroom.com/starwars/sw.html>http://www.densgameroom.com/starwars/sw.html
>
>
>Dennis
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Mon Aug 20 11:42:29 2001
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:33:34 EDT