RE: WG6100 display problems

RE: VECTOR: WG6100 display problemsDennis,
I have had this problem before and I replace the AVG w/Clay's substitute
http://www.multigame.com/AVG.html

p.s. Also look into reflowing the solder on the wires leading to the chassis
trans, they often get lose from handing and give weird display anomalies.

Justin Monast
http://www.arcadecoinops.com
  -----Original Message-----
  From: owner-vectorlist@synthcom.com
[mailto:owner-vectorlist@synthcom.com]On Behalf Of Dennis Shirk
  Sent: Tuesday, August 21, 2001 8:28 AM
  To: 'vectorlist@synthcom.com'
  Subject: RE: VECTOR: WG6100 display problems

  I have two AVG PCBs, but only a single AVG processor. If I test on the
other AVG PCB, I have to move the processor from one to the other. The same
display problems exist on both boards using the same processor. I was
wondering if the processor could be responsible, but the consensus so far
seems to suggest that it is unlikely.

  Dennis

  -----Original Message-----
  From: Chris Loggans [mailto:cloggans@yahoo.com]
  Sent: Tuesday, August 21, 2001 11:04 AM
  To: vectorlist@synthcom.com
  Subject: RE: VECTOR: WG6100 display problems

  Dennis,

     I don't remember seeing this in any of the
  messages, but do you know for sure that the SW
  boardset is OK? I've seen this problem with Tempest
  and it was a problem in the analog output section of
  the vector generator, not the monitor.

  -Chris

  --- Dennis Shirk <dshirk@pipelineInteractive.com>
  wrote:
> This is in reference to the following URL:
>
> http://www.densgameroom.com/starwars/sw.html
>
> I received a couple bits of advice yesterday. I
> spent the evening messing
> around with the lin and bip pots on the star wars
> boardset. It still would
> not clean up the vectors. About the only thing I
> found would help is
> reducing the over-all screen size by about 35%. This
> brought the vectors
> into alignment with each other, but left me with a
> very small playing area.
> I also noticed the colors brightened considerably
> when I did this. Could
> this be a sign of a failing HV?
>
> Any other suggestion or tidbits of knowledge?
>
> Thanks!
>
> Dennis
>

  __________________________________________________
  Do You Yahoo!?
  Make international calls for as low as $.04/minute with Yahoo! Messenger
  http://phonecard.yahoo.com/
  --------------------------------------------------------------------------
-
  ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
the
  ** message body to vectorlist-request@synthcom.com. Please direct other
  ** questions, comments, or problems to neil@synthcom.com.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Tue Aug 21 11:30:02 2001