Re: WG 6100 Deflection Board Problem

From: jerry madsen <jetskimod_at_yahoo.com>
Date: Wed Aug 29 2001 - 14:23:00 EDT

They are boxy looking but they are not caps they are
resistors,I believe 1.5 or 15 ohm one of the two.in
between the heat sinks.
                 Jerry.

--- nej@airmail.net wrote:
> jerry madsen <jetskimod@yahoo.com> said:
>
> I have
> > also replaced the 2 White ceramic resistors in the
> > X-Amp and Y-amp section.It still has this problem.
>
> Are you referring to the boxy looking caps at
> C603/C703 (not sure about that
> location)? I believe the general consensus is to
> remove those caps altogether
> as they weren't on the final revision 6100.
> Removing those caps certainly
> helped clean up that quadrant of the picture in the
> monitors I've worked
> on. Sounds like your problems may be a bit more
> serious than that though.
>
> Noel
>
>
---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from vectorlist, send a message
> with "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@synthcom.com.
> Please direct other
> ** questions, comments, or problems to
neil@synthcom.com.

__________________________________________________
Do You Yahoo!?
Get email alerts & NEW webcam video instant messaging with Yahoo! Messenger
http://im.yahoo.com
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Wed Aug 29 11:23:57 2001

This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:33:36 EDT