Chris,
If you went with the 1.2a ones, you'd be fine. IF there were 2.4a going through
MC1, I'd bet you'd have a problem... The ones I used were probably of the 680ma
type, but I can't say for sure. I don't believe tolerance is going to be a huge
deal. It just needs to be somewhat close. 6.4a is probably way overkill..
JB
"Christopher X. Candreva" wrote:
> Since I sent this to Joe anyway -- anyone have an idea how much current is
> going through that red can on the Ampliphone HV board ?
>
> I'm seeing the following in the Mouser catalog for 10uH coils: 680 ma 10%
> tolerance for $.20/ea, 1.2 amps 20% for only $.35 -- but does the tolerance
> make a big difference ?
>
> Wow -- DigiKey doesn't seem to have anything comparable, but we can go to
> 6.4 amps for about $2 each.
>
> Any idea what ballpark I should be looking in ?
>
> -Chris
>
> ==========================================================
> Chris Candreva -- chris@westnet.com -- (914) 967-7816
> WestNet Internet Services of Westchester
> http://www.westnet.com/
> ---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to vectorlist-owner@synthcom.com.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
Received on Wed Feb 5 17:26:37 2003
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:34:20 EDT