RE: What is the difference between...

The speeds of the two crystals have also been reduced, but I don't
remember off hand what they are...

Justin

-----Original Message-----
From: owner-vectorlist@synthcom.com
[mailto:owner-vectorlist@synthcom.com] On Behalf Of Tony Jones
Sent: Wednesday, May 28, 2003 11:08 AM
To: vectorlist@synthcom.com
Subject: Re: VECTOR: What is the difference between...

The crystal is different, the dedicated runs slightly faster, I believe
because the Amplifone display could handle a slightly higher vector
rate.

On the conversion pcb, Pre-X and Pre-Y are taken from the AVG and passed
to
two pins on the smaller edge connector. The traces on these pins are cut
and
the wires bridged over. These outputs are inputs to the 1495
multipliers
on the conversion board, which handle the pincushion compensation that
is standard on the Amplifone tube, but required by a WG.

Also, every dedicated boardset I've seen (including mine) has a real
quad pokey, every conversion board has a quad pokey eliminator.

Conversion boards also have a serial# sticker on them beginning CKxxxxx,
at least I think it's CK. Dedicated are URxxxx I believe, but it's been
a while.

Tony

------------------------------------------------------------------------

---
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.