Re: Major Havoc R186

Don't forget the second generation whirly-gig that came with the
SpaceDuel/Gravitar to MajorHavoc kits. I recall a recent thread (vectorlist)
where people were saying the newer whirlygig didn't work properly when
connected to a Tempest board, issue IIRC was that rate of movement.

tony

> Does it make a difference if you're using an original MH roller or a
> Tempest spinner?
>
>
> At 02:01 AM 9/21/2003 -0500, you wrote:
> >This is for the "Rev B kit boards." Every board I have seen has fallen
> >into this category. I would say ALL are worth checking.
> >
> >And it R186, not 159, my mistake..
> >
> >Anyhow, it's tough to see, but once you see it, it is VERY obvious that
> >something is supposed to go there. This was either directly next the
> >quad pokey socket or the LETA chip as my memory seves. I have yet to
> >scan the SB, will do soon..
> >
> >JB
> >
> >-----Original Message-----
> >From: Tony Jones [mailto:tony@tonyjones.com]
> >Sent: Saturday, September 20, 2003 4:30 PM
> >To: vectorlist@vectorlist.org
> >Subject: Re: VECTOR: Major Havoc R159
> >
> >
> >What boardsets is the SB for, dedicated (UR), conversion (CK) or both?
> >
> >Tony
> >
> > > I wasn't aware of this, and naturally have never checked my board.
> > >
> > > Is the SB on the net somewhere? I'd be interested in adding the
> >resistor.
> >
> >
> >------------------------------------------------------------------------
> >---
> >** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
> >the
> >** message body to vectorlist-request@vectorlist.org. Please direct
> >other
> >** questions, comments, or problems to chris@westnet.com .
> >
> >---------------------------------------------------------------------------
> >** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
> >** message body to vectorlist-request@vectorlist.org. Please direct other
> >** questions, comments, or problems to chris@westnet.com .
>
> --
> Franklin Bowen (Franklin@Bowen.net)
> http://Franklin.Bowen.net
>
>
> ---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@vectorlist.org. Please direct other
> ** questions, comments, or problems to chris@westnet.com .

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@vectorlist.org. Please direct other
** questions, comments, or problems to chris@westnet.com .
Received on Sun Sep 21 10:03:09 2003