Re: G08 flyback repair

From: peter jones <highwayman2000_at_mail.ru>
Date: Sat Jul 14 2007 - 15:44:21 EDT

-----Original Message-----
From: andre <livnfree_can@yahoo.com>
To: vectorlist@vectorlist.org
Date: Sat, 14 Jul 2007 12:08:45 -0700 (PDT)
Subject: VECTOR: G08 flyback repair

>
> I have a monitor I tried to pull the diode out of a
> few months back..broke the wire from flyback to the
> diode. Does anyone know if I could sloder the wires,
> and rt silicone it? If so is there a common (home
> depot) brand of silicone that would insulate good enough?
>

well if you can get to it then there's no reason you cant solder it,
but i'd use high-voltage insulating epoxy rather than silicone rubber.

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Sat Jul 14 15:44:24 2007

This archive was generated by hypermail 2.1.8 : Sat Jul 14 2007 - 18:50:00 EDT