Re: Re: G08 flyback repair

I can get to it...I'd have to cut back the rubber a
bit..its pretty much mid-way from the transformer to
the socket for the diode.

Is there a specific brand or type you have used?

--- peter jones <highwayman2000@mail.ru> wrote:

>
> -----Original Message-----
> From: andre <livnfree_can@yahoo.com>
> To: vectorlist@vectorlist.org
> Date: Sat, 14 Jul 2007 12:08:45 -0700 (PDT)
> Subject: VECTOR: G08 flyback repair
>
> >
> > I have a monitor I tried to pull the diode out of
> a
> > few months back..broke the wire from flyback to
> the
> > diode. Does anyone know if I could sloder the
> wires,
> > and rt silicone it? If so is there a common (home
> > depot) brand of silicone that would insulate good
> enough?
> >
>
> well if you can get to it then there's no reason you
> cant solder it,
> but i'd use high-voltage insulating epoxy rather
> than silicone rubber.
>
>
---------------------------------------------------------------------------
> ** Unsubscribe, subscribe, or view the archives at
> http://www.vectorlist.org
> ** Please direct other questions, comments, or
> problems to chris@westnet.com
>

 
____________________________________________________________________________________
Don't pick lemons.
See all the new 2007 cars at Yahoo! Autos.
http://autos.yahoo.com/new_cars.html
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Sat Jul 14 18:11:16 2007