Doug, Do you have a dead WG6100 board? I'm needing the Horizintal Driver
Transformer (T901).
Robert
On Sun, 2007-07-15 at 23:47 -0400, Doug Hill wrote:
> Hello gang.
>
> I have a tangential question for the vector list but I'm hoping you'll humor me. In restoring two Tempest games over the last year I now have a collection of Tempest PCBs that basically don't work. With the help of this list [and all the past posts] I now have two solid WG6100s to which I can attach these dead boards but I am at a loss as to where to start with the repairs on the game boards.
>
> When hooked up into one of the working cabinets most are just dead [no flashing start buttons, test switch does nothing, and obviously spot killer is on]. As far as I can tell the boards look complete [when compared to my two working board sets] and I have done the usual examination of the interconnect cable and the connectors on both PCBs.
>
> I've googled around quite a bit and almost all of the information online assumes the game PCBs are working and the WG6100 is the culprit - I now have the opposite situation. Is there any recommended reading as to where to start with these boards or do any of you guys have some places I should start?
>
> Thanks for any tips you may have and again my apologies for the slightly off-topic question...
>
> -doug
>
>
>
>
> ---------------------------------------------------------------------------
> ** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to chris@westnet.com
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Mon Jul 16 20:05:55 2007
This archive was generated by hypermail 2.1.8 : Mon Jul 16 2007 - 20:50:00 EDT