Never run the HV supply without a load. The connection to the CRT must be
there. Never leave the anode wire open. That is a serious no-no on any
monitor, vector or otherwise.
William Boucher
----- Original Message -----
From: "John Robertson" <pinball@telus.net>
To: <vectorlist@vectorlist.org>
Sent: Saturday, February 21, 2009 2:51 AM
Subject: VECTOR: B&W HV cages...regulation failing...
> OK, I've got a couple of WG HV cages for Asteroids and both are croaking
> when warm.
>
> What appears to happen is the HV diode is getting hot just sitting on the
> bench, but not connected to anything other than the HV lead! Ihave
> replaced the HV lead with another from another flyback (colour) and the
> diode still heats up.
>
> Have cleaned the wire, and support post, yet somewhere there is a current
> leak. Have insulated the wire with a silicone collar where it goes through
> the metal cage (and the plastic bit there).
>
> Now, if I remove the outside half of the HV wiring - from the positive end
> of the HV diode - and simply cap the diode with a plastic pen cap, then
> the voltage regulation is stable, and the diode stays cool - as expected.
>
> However if I then put the HV wire back on the diode (carefully replaced
> insulators of course!) the sucker gets hot and the HV regulation fails
> (voltage drops). Note that the anode cap is sitting inside a very clean,
> insulated ceramic mug for isolation and safety (mine!).
>
> Very curious! Will continue working on it in the next day or two and
> report my findings - but this seems to have a bearing on why some cages
> just seem to die and yet, may be good if the cause of the leakage is
> found...
>
> John :-#(#
>
> --
> John's Jukes Ltd. 2343 Main St., Vancouver, BC, Canada V5T 3C9 Call
> (604)872-5757 or Fax 872-2010 (Pinballs, Jukes, VideoGames)
> www.flippers.com "Old pinballers never die, they just flip
> out"
>
> ---------------------------------------------------------------------------
> ** Unsubscribe, subscribe, or view the archives at
> http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to
> chris@westnet.com
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Sat Feb 21 09:44:17 2009
This archive was generated by hypermail 2.1.8 : Sat Feb 21 2009 - 11:50:01 EST