Re: Steps for my first B&W vector discharge

This method should work fine. I've been doing it without the resistor for years.

Thanks,

-Al Warner-

On Apr 14, 2012, at 8:58 AM, "Altan (GAPAS)" <pinball@aaarfamily.com> wrote:

>
> I need to clean the HV diode in my 19V2000 B&W monitor for an Asteroids Deluxe. I'm going to attempt my first monitor discharge… I'd appreciate a second set of eyes on these steps.
>
> 1) Get flathead screwdriver with plastic handle
> 2) Get alligator clips
> 3) Get 1M ohm resistor (3 Watt)
> 4) Clip to metal part of driver, put resistor inline, clip to monitor chassis
> 5) Put one hand in pocket
> 6) Slide screwdriver blade under suction cup, move it toward center and touch anode clips
> 7) Leave it there for a few seconds. Sadly, with the resistor, it appears you don't get any feedback showing you did it
> 8) Wait 5 minutes, repeat once more
>
> That's it. Sounds right?
>
> It looks like you just need to take it on faith that you discharged it… Any hints to check? I don't want to find out I didn't discharge it when I remove the HV diode.
>
> Thanks!
>
> … Altan
> www.aaarpinball.com---------------------------------------------------------------------------
> ** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to chris@westnet.com
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Sat Apr 14 09:15:07 2012