Re: K6100 Focus

Also measure for continuous from focus pin to the molecular connector
On Jul 6, 2012 7:45 PM, "Maxstang" <maxstang@sbcglobal.net> wrote:

> You have to remove the socket from the board to open it and get inside to
> the focus wire.
>
> Sent from my iPhone
>
> On Jul 6, 2012, at 4:32 PM, Chuck <chuck@localsurfer.com> wrote:
>
> I think I should be insulted!!
>
> Just joking, I am far from perfect. Will take a look at them this evening
> or tomorrow.
>
> Chuck
>
>
> On Jul 6, 2012, at 1:50 PM, Rodger Boots wrote:
>
> Seeing that it worked before you overhauled it (didn't it?) check that you
> put all electrolytic capacitors in correctly. A reversed one could cause
> this.
> On Jul 6, 2012 9:18 AM, "Chuck" <chuck@localsurfer.com> wrote:
>
>> Anyone? Still lost on this one.
>>
>> Chuck
>>
>>
>> On Jul 4, 2012, at 10:48 PM, Chuck wrote:
>>
>> > Hey all,
>> > I have a K6100 from my Tempest that I did a full rebuild on with
>> all the bells and whistles from Bob Roberts. All seems to have went well
>> except that it now will not stay in focus. I tried swapping out the flyback
>> with another one and the problem is still there. I have looked at the pins
>> and socket on the neck and neck board and they all seem to fine, no signs
>> of corrosion. The connector that goes from the high voltage cage to the
>> neck board is not at issue as far as I can tell, there isn't any changes
>> when I wiggle it around. The weird part is that when I turn the game on it
>> is perfect for a couple of minutes and then drifts out of focus to about
>> the same point all the time. I thought it might be a heat problem, but if I
>> turn the game off for just a few seconds and right back on, it is in good
>> focus again for a couple of minutes. No time for it to cool off. I miss
>> playing my Tempest.
>> >
>> > Thanks,
>> >
>> Chuck---------------------------------------------------------------------------
>> > ** Unsubscribe, subscribe, or view the archives at
>> http://www.vectorlist.org
>> > ** Please direct other questions, comments, or problems to
>> chris@westnet.com
>>
>>
>> ---------------------------------------------------------------------------
>> ** Unsubscribe, subscribe, or view the archives at
>> http://www.vectorlist.org
>> ** Please direct other questions, comments, or problems to
>> chris@westnet.com
>>
>
> ---------------------------------------------------------------------------
> ** Unsubscribe, subscribe, or view the archives at
> http://www.vectorlist.org ** Please direct other questions, comments, or
> problems to chris@westnet.com
>
>

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Fri Jul 6 20:16:42 2012