Re: Sharp Monitor Schematics

<x-flowed>
Kurt, could you ask them to mail them out, then you could scan them and
upload to Spies or some such site...

John :-#)#

At 10:21 AM 9/17/01, you wrote:
>Turns out that "KTE-XX" and "KTW-XX" are old and not on the website -- but
>they are willing to fax out the schematics (I hope they are legible).
>
>As an aside we talked about Sharp Image monitors and Isolation transformers
>since that (or a lack of one) is what blew up this monitor.
>
>The tech had this to say about Sharp Image monitors:
>
> - IF the SI monitor is an "old" monitor - chassis is a KTE-XX or KTW-XX
> then you HAVE to use an isolation transformer. Be sure to check the
> chassis.
>
> - IF the SI monitor is a "new" monitor - chassis is a SI-XXX then you
> shouldn't use an isolation transformer. And he said a common problem
> is people still wire them through the existing isolation transformer
> which is typically rated for .5A or 1A -- and these monitors draw
> slightly more than that (125W). So the transformers burn up.
>
>Kurt
>
> >
> > Guess you'll have to call the phone number on the bottom of the
> > schematic and ask them what the deal is.
> >
> >
> >
> > Kurt Mahan wrote:
> > >
> > > Ok -- so my monitor doesn't match the schematic. The box for the monitor
> > > says "SI-313". The schematic on the website (Schematic-F) doesn't
> match the
> > > PCB.. The chassis says KTW-21".. Any thoughts as to what the "right"
> > > schematic is? The PCB itself says Sharp Image on it.
> > >
> > > > Try http://www.sharpimage.net/techsupp.html , they seem to have PDF
> > > > schematics there for all their monitor.
> > > >
> > > > NOTE: Perhaps it would be a good idea to back these up to spies or
> > > > stormaster??
> > > > >
> > > > > Hi --
> > > > >
> > > > > I've got a 13" Sharp Image monitor that I need to fix. But I
> need a set
> > > > > of schematics. Are they up on the web anywhere?
>---------------------------------------------------------------------------
>** To UNSUBSCRIBE from rasterlist, send a message with "UNSUBSCRIBE" in the
>** message body to rasterlist-request@synthcom.com. Please direct other
>** questions, comments, or problems to neil@synthcom.com.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from rasterlist, send a message with "UNSUBSCRIBE" in the
** message body to rasterlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.

</x-flowed>
Received on Mon Sep 17 11:54:19 2001