Re: The first 25" Major Havoc lives!

INCREDIBLE!!! ;-)

What's that giant rumbling noise I hear? Everyone rushing out to there workshops to look for "that darned wells gardner yoke I left at here somewhere..."..

So you did end up using the WG 6100 yoke, correct? What is the model number of the tube you used? Do you know if the tube was medium or low res?

Thanks,
Noel

--
On Mon, 07 Feb 2000 10:53:03   Jon Raiford wrote:
>For those of you who have been following my project, I have finally finished the technical portion.  My Major Havoc now lives in full color (converged pretty good too) in a  25" 720 cabinet complete with custom control panel.  There is an awful log of bowing on the display, so it is probably worth my while to install one of Clay's display correctors (Clay: any chance you want to donate one to a good cause?)
>
>I do have one question.  During the convergence, even though it all went smoothly, it is still a little off at the top and bottom of the screen.  The red and blue are both dead on with each other, but the green gradually pulls away the further away from the center you get.  The convergence magnets don't seem to fix it, and the yoke appears to be at its optimal location, yet I still seem to have this problem.
>
>Is this why magnetic shunts are sometimes used?  Could it be the location of the magnetic convergence assembly itself?  Or is this just the effect of a yoke not designed for a particular tube?  As it is, it does look pretty good already.  I guess I'd just like to make it perfect.  I'll post a picture later tonight showing the effect that I'm seeing.
>
>Jon
>
>ftp://arcade.ne.mediaone.net/incoming/720-to-MH/720toMH_Working.jpg
>
>---------------------------------------------------------------------------
>** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
>** message body to vectorlist-request@synthcom.com. Please direct other
>** questions, comments, or problems to neil@synthcom.com.
>
--== Sent via Deja.com http://www.deja.com/ ==--
Share what you know. Learn what you don't.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.