Re: WG 6100 Deflection Board Problem

From: jerry madsen <jetskimod_at_yahoo.com>
Date: Wed Aug 29 2001 - 18:25:21 EDT

Noel,
    I did use the non-inductive resistor,I had no
trouble finding them.I will remove the two caps that
you mentioned C603 C703 and see what happens.
          Jerry.

--- nej@airmail.net wrote:
> jerry madsen <jetskimod@yahoo.com> said:
>
> > Noel,
> > You are refering to the caps that are by the
> > resistors that I am talking about,correct?If so I
> did
> > replace them.I dont have the scematics with me
> right
> > now so I am going by memory to where they are at.
> > Jerry.
>
>
> Doh! I see that you said resistors, not caps in
> your original post. In any
> event, if you did replace the 1.5ohm 10 watt
> resistors at R610/R710 it is
> recommended that you use non-inductive resistors. I
> haven't really looked for
> a source for these but if you check a few months
> back I believe someone posted
> on this.
>
> Still you should remove the 0.47uf caps at
> C603/C703. They look like small
> plastic boxes so they're easy to recognize (unless
> they've been replaced
> before with a different style cap). These caps
> aren't needed for proper
> functioning of the board and can cause jiggly
> vectors in the lower half of the
> screen (with the monitor laying horizontal as in
> Space Duel)
>
> Noel
>
---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from vectorlist, send a message
> with "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@synthcom.com.
> Please direct other
> ** questions, comments, or problems to
neil@synthcom.com.

__________________________________________________
Do You Yahoo!?
Get email alerts & NEW webcam video instant messaging with Yahoo! Messenger
http://im.yahoo.com
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Wed Aug 29 15:26:21 2001

This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:33:36 EDT