Re: Amplifone Deflection

 Make sure you check every resistor and every diode, those can cause
deflection problems also.
Dont just concentrate on the transistors. i made that mistake ,
eventually i found out i had and open diode.
Dan

Joe Bachmann wrote:

>Time to go fishing for ideas.
>
>I have an Amplifone delfection baord with what I think is an odd issue.
>
>This board had a bad Q14. Q14 was/is a MPSU56 (MPSU57 replacement.)
>
>There is no deflaection on the screen other than a haze. The spot killer is not on.
>
>The large resistor on the X side is heating up much more than it should. The one on
>the Y side is heating up perhaps slighty more than normal.
>
>Q14 was bad and was replaced.
>
>All transistors on the X side and spot killer ciruit have been checked. All jumpers
>have been replaced with wire.
>
>No other components are abnormally warm.
>
>
>Any ideas?
>
>Thanks,
>Joe
>
>---------------------------------------------------------------------------
>** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
>** message body to vectorlist-request@synthcom.com. Please direct other
>** questions, comments, or problems to neil@synthcom.com.
>

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Tue Mar 26 03:08:58 2002