RE: G05 802 help please

Have any of the TPS98's been replaced before with this monitor? Remember
all the TO-92s (TIS or TPS98s) on the GO5 were silkscreened backwards
*except the 3906's* Just something to look out for and could easily blow
your F600 if you follow the silkscreen outline of the TO-92 (you have to
reverse it)

As for the spot killer, I've come across several GO5's in the last few
months that had a leaky TPS98 in that section... Looked good using a
standard diode check, but would flake out with power applied. Never blew a
fuse in these cases or any instances with a faulty spot killer section, (at
least that I've come across). In your case, F600 is blowing and you're
getting a horz line.. it has to be in the Y section.

James Hagen

> -----Original Message-----
> From: owner-vectorlist@synthcom.com
> [mailto:owner-vectorlist@synthcom.com]On Behalf Of Bachmann, Joe
> Sent: Friday, February 14, 2003 2:06 PM
> To: vectorlist@synthcom.com
> Subject: VECTOR: G05 802 help please
>
>
>
> I have a 15" G05 802 deflection board which I just can't seem to get
> working.
>
> The problem is on the Y side. The large 2ohm resistor (r620), r618, and
> r613 get nice and toasty warm. The spot killer is flickering while this
> is happening and then F600 blows. This all happens rather quickly and of
> course a horizontal line appears on the screen.
>
> What I have done is pulled all of the 6xx parts and tested. All tested
> good. Transistors, resistors, diodes......
>
> Could the spot killer circuitry be causing this?
>
> Thanks,
> JB
>
> ------------------------------------------------------------------
> ---------
> ** To UNSUBSCRIBE from vectorlist, send a message with
> "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to vectorlist-owner@synthcom.com.
>

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
Received on Fri Feb 14 21:32:57 2003