RE: G05 802 help please

I actually have a Fluke 12. Yes, it does rock! I bought it about 7 years
ago and have only had to change the bat once. And that was last year!

I have checked all my transistors; they were all put in the right way.
Thanks for the tip. Another board I had did have them backwards.

At this point, I still have yet to figure it. I know the chassis
transistors are good as a working deflection board works fine in this
chassis.

Any more ideas? Maybe something in the power supply? I'm kind of at a
loss here.

JB

-----Original Message-----
From: Andy Welburn [mailto:andy@andys-arcade.com]
Sent: Monday, February 17, 2003 11:22 AM
To: vectorlist@synthcom.com
Subject: Re: VECTOR: G05 802 help please

> > I have a 15" G05 802 deflection board which I just can't seem to get
> > working
> >
> > The problem is on the Y side. The large 2ohm resistor (r620), r618,
and
> > r613 get nice and toasty warm. The spot killer is flickering while
this
> > is happening and then F600 blows. This all happens rather quickly
and of
> > course a horizontal line appears on the screen
> >
> > What I have done is pulled all of the 6xx parts and tested. All
tested
> > good. Transistors, resistors, diodes.....
> >
> > Could the spot killer circuitry be causing this?
> >
> > Thanks,
> > JB

Are you sure your meter is capabale of detecting 'leakage' in
transistors?

you may well have bad transistors, but your meter can't see them as
bad...

I changed my meter when i realised this.. the Fluke 12 rocks...

Andy

------------------------------------------------------------------------

---
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.