Re: Modern Vector demo!

Or perhaps just your system audio volume for at least crude control?

Chad

----- Original Message Follows -----
> About the output ranges- (this is from the readme in the source)
>
> " Once the software is running, it may be necessary to adjust the
> Volts/Div
> controls (usually both channels will be set to the same range).
> Mine seems
> to work best at somewhere between 50 and 200mV (millivolts) per
> division."
>
> So, it just sounds like an amplifier (audio) is all that's needed to
> adjust the signal to fit any vector display input. I didn't read
> enough to determine how any intensity input to the scope is modified.
> It sounds like these are just X and Y outputs (from the left/right
> channels).
>
> Kerry
>
> ---- peter jones <highwayman2000@mail.ru> wrote:
> > http://sourceforge.net/projects/scopeshapes

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Tue Aug 7 16:28:38 2007