Cinelabs HV-2000 install on WG 6100

Hi gang.

I'm rebuilding a HV cage for a WG K6100 and have installed the Cinelabs replacement HV transformer since the cage came to me w/o a transformer installed. However, as you can see by the referenced pictures [below] I'm missing the two wires that connect to the focus assembly and go to a 2-wire socket [that then goes to the neck board]. Obviously these are just some heavy guage wires that are easy to replace. However, these wires normally have rubber boots on them where they connect to the focus assembly. Since they are there I'm assuming they are required, right? Can anyone recommend a replacement for these or alternative solution that is safe?

Also, since the HV unit was missing the old transformer I no longer have the plastic insulator that goes between the cage and the focus assembly. I know it's just a piece of plastic but anyone have any recommendations on materials to use?

Thanks for any hints you guys have...

-doug

Pictures: http://gallery.mac.com/doughill303#100033

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Thu Oct 11 11:07:11 2007