Re: Cinelabs HV-2000 install on WG 6100

From: peter jones <highwayman2000_at_mail.ru>
Date: Thu Oct 11 2007 - 13:43:17 EDT

-----Original Message-----
From: Doug Hill <doug@grouplogic.com>
To: "<vectorlist@vectorlist.org>" <vectorlist@vectorlist.org>
Date: Thu, 11 Oct 2007 11:07:06 -0400
Subject: VECTOR: Cinelabs HV-2000 install on WG 6100

> Hi gang.
>
> I'm rebuilding a HV cage for a WG K6100 and have installed the Cinelabs replacement HV transformer since the cage came to me w/o a transformer installed. However, as you can see by the referenced pictures [below] I'm missing the two wires that connect to the focus assembly and go to a 2-wire socket [that then goes to the neck board]. Obviously these are just some heavy guage wires that are easy to replace. However, these wires normally have rubber boots on them where they connect to the focus assembly. Since they are there I'm assuming they are required, right? Can anyone recommend a replacement for these or alternative solution that is safe?

you can get those boots from an old tv set, or use high-voltage rubber compound.

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Thu Oct 11 13:46:37 2007

This archive was generated by hypermail 2.1.8 : Wed Oct 31 2007 - 10:50:01 EDT