Re: K6100 Focus

From: Chuck <chuck_at_localsurfer.com>
Date: Fri Jul 06 2012 - 10:17:59 EDT

Anyone? Still lost on this one.

Chuck

On Jul 4, 2012, at 10:48 PM, Chuck wrote:

> Hey all,
> I have a K6100 from my Tempest that I did a full rebuild on with all the bells and whistles from Bob Roberts. All seems to have went well except that it now will not stay in focus. I tried swapping out the flyback with another one and the problem is still there. I have looked at the pins and socket on the neck and neck board and they all seem to fine, no signs of corrosion. The connector that goes from the high voltage cage to the neck board is not at issue as far as I can tell, there isn't any changes when I wiggle it around. The weird part is that when I turn the game on it is perfect for a couple of minutes and then drifts out of focus to about the same point all the time. I thought it might be a heat problem, but if I turn the game off for just a few seconds and right back on, it is in good focus again for a couple of minutes. No time for it to cool off. I miss playing my Tempest.
>
> Thanks,
> Chuck---------------------------------------------------------------------------
> ** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to chris@westnet.com

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Fri Jul 6 10:18:26 2012

This archive was generated by hypermail 2.1.8 : Fri Jul 06 2012 - 14:50:01 EDT