Re: K6100 Focus

Seeing that it worked before you overhauled it (didn't it?) check that you
put all electrolytic capacitors in correctly. A reversed one could cause
this.
On Jul 6, 2012 9:18 AM, "Chuck" <chuck@localsurfer.com> wrote:

> Anyone? Still lost on this one.
>
> Chuck
>
>
> On Jul 4, 2012, at 10:48 PM, Chuck wrote:
>
> > Hey all,
> > I have a K6100 from my Tempest that I did a full rebuild on with
> all the bells and whistles from Bob Roberts. All seems to have went well
> except that it now will not stay in focus. I tried swapping out the flyback
> with another one and the problem is still there. I have looked at the pins
> and socket on the neck and neck board and they all seem to fine, no signs
> of corrosion. The connector that goes from the high voltage cage to the
> neck board is not at issue as far as I can tell, there isn't any changes
> when I wiggle it around. The weird part is that when I turn the game on it
> is perfect for a couple of minutes and then drifts out of focus to about
> the same point all the time. I thought it might be a heat problem, but if I
> turn the game off for just a few seconds and right back on, it is in good
> focus again for a couple of minutes. No time for it to cool off. I miss
> playing my Tempest.
> >
> > Thanks,
> >
> Chuck---------------------------------------------------------------------------
> > ** Unsubscribe, subscribe, or view the archives at
> http://www.vectorlist.org
> > ** Please direct other questions, comments, or problems to
> chris@westnet.com
>
> ---------------------------------------------------------------------------
> ** Unsubscribe, subscribe, or view the archives at
> http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to
> chris@westnet.com
>

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Fri Jul 6 13:51:08 2012