RE: Need some help with an Electrohome G08

Check the 10-pin connector at the HV unit. I've seen more than once that
flexing the HV PCB by pressing on the 10-pin connector will cause the HV to
work.

When the monitor is powered up, do you hear deflection chatter?

> -----Original Message-----
> From: Matt Rossiter [mailto:rossiter@ni.net]
> Sent: Thursday, May 10, 2001 4:25 AM
> To: vectorlist@synthcom.com
> Subject: VECTOR: Need some help with an Electrohome G08
>
>
> I've been working on getting an Eliminator restored and
> almost have the
> monitor working but I'm running into a problem. When I plug
> the monitor
> into a game that I know is working it will sit there and do
> nothing for
> a while. Even the power transistors are cold, but then every
> once in a
> while the high voltage will kick in and display a couple of
> dots in the
> center of the screen and then the high voltage will shutoff and the
> monitor will be quiet again.
>
> I've checked all the solder joints and they look good and none of the
> fuses are blowing. Just wondering if anyone has any ideas
> before I pull
> out the oscilloscope.
> Matt
>
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Thu May 10 10:15:32 2001